I'm pretty sure this may have been covered in the past but I'm curious about the mold quality differences between the 2 and 6 cavity Lee molds. I remember that the old style 2 cavity molds were of a softer aluminum than the 6 cavity. With the recent addition of the new style 2 cavity I was wondering what your opinions are of those molds and are they up to the quality of the bigger molds. As hard as I tried I would end up scouring the the old style 2 cavity molds. I have used a NEI mold and I guess the aluminum was so hard it was like using a steel mold, no worries. The reason I bring this up is I noticed they now offer the 22 Bator and 358-200fn molds in both configurations and am trying to figure out which style to pursue. I know I could always go with one of the custom makers and get a really good mold but available finances put a damper on that route. Thanks in advance.
Robert Homan