Just got a 327 federal with a 5.5 barrel .and I have 2 lee mold 100gr round nose, and a 98gr semi wade cutter. I was wanting a heavier bullet say 115gr rf or wide swc.any ideas on this?
got new gun
- 1.2K Views
- Last Post 30 August 2016
mike corbett
posted this
26 April 2015
Thanks for your advice did not find one so I order a 31120f from accurate mold
Attached Files
nimrod
posted this
26 April 2015
Accurate Molds 31-115J can be ordered without gas check if desired.
RB
Attached Files
Ken Campbell Iowa
posted this
30 August 2016
i have used lyman 3118 in 32-20....pretty consistent without resorting to tricks ...and you can find this mold used occasionally ... as always, check for fit , the old molds vary quite a bit .
ken
Attached Files
Categories
- All Categories
- General Polls
- Contact Us w/ Forum Issues
- Welcome to The Cast Bullet Association Forum
- General
- Bullet Casting
-
Guns and Shooting
- AR Platform
- TC Contenders & Other Single Shot Handguns
- Shotguns
- Informal Matches & Other Shooting Events
- Gunsmithing Tips
- Gun Cleaning & Maintenance
- Optics
- Benchrest Cast Bullet Shooting
- Military Bench Rest Cast Bullet Shooting
- Silhouette Shooting
- Postal Match Cast Bullet Shooting
- Factory Guns
- Black Powder Cartridge
- Hand Guns
- Lever Guns
- Single Shot Rifles
- Bolt Action Rifles
- Military Surplus Rifles
- Plinkers Hollow
- Muzzleloaders
- Hunting
- Reloading
- Buy, Sell or Trade
- Other Information & Reference
Search
This Weeks High Earners
- Aaron 25
- jeff houck 20
- Tom Acheson 17
- Wilderness 14
- John Carlson 13
- sghart3578 10
- MarkinEllensburg 10
- Spindrift 5
- alphabrass 5
- SkinnerD 5