Barrel liners

  • 577 Views
  • Last Post 31 December 2022
Premod70 posted this 29 December 2022

Question to those in the know; is a barrel liner legal in a correct barrel/ receiver military combination. Possibly a way to bring a shot out rifle back up to competitve standards.

Dale Flinchum

Attached Files

Order By: Standard | Newest | Votes
RicinYakima posted this 29 December 2022

(a) Military Rifles

[1] Issue - Any military service rifle issued to any nation and legally sold as surplus in the US and in strictly as issued configuration. The only modifications allowed to the Issue rifle are -- front sight height may be raised or lowered as long as the original profile is kept, the sling and swivel may be removed and a slip on recoil pad may be used.

[2] Modified Iron - Any military service rifle issued to any nation and legally sold as surplus in the US and with issue action and barrel. Stocks may be either issue stocks, modified military stocks or sporter stocks. Modified military or sporter stock forearms may not be wider nor flatter on the bottom than the original stock issued for that rifle. Modified military or sporter stocks may not weigh more than the original issued stock. Any trigger and iron sight may be used and glass bedding is allowed. The barrel may be shortened to a minimum of 20 inches unless that rifle was issued as less then 20 inches.

[3] Modified Scope - Any military service rifle issued to any nation and legally sold as surplus in the US and with issue action and barrel. Stocks may be either issue stocks, modified military stocks or sporter stocks. Modified military or sporter stock forearms may not be wider or flatter on the bottom than the original stock issued for that rifle. Modified military or sporter stocks may not weigh more than the original issued stock. Any trigger and scope up to a maximum of 6 power may be used. Glass bedding is allowed. The barrel may be shortened to a minimum of 20 inches unless that rifle was issued as less then 20 inches.

I would have to say no, but I am no longer a match director, so someone else needs to look at this. 

Attached Files

  • Liked by
  • Bud Hyett
John Carlson posted this 30 December 2022

The answer is no.  For all classes in military competition the action and barrel must be issue.  Any modifications other than shortening as allowed in the modified classes would disqualify it.

John Carlson. CBA Director of Military Competition.

Attached Files

  • Liked by
  • Bud Hyett
  • RicinYakima
Ken Campbell Iowa posted this 30 December 2022

no dog hunting here ... but an advisory thought...

i believe the most significant " unfair advantage " from a new liner job would be a possible

* better chamber * ...

********************

i believe a match chamber ( or even a good SAAMI job )  in an old military barrel is better than a typical military chamber in, say, a Lilja barrel ...

...and for the same reason, a " set back and rechamber " of the military barrel can be an advantage .

just some thoughts ... ken

 

Attached Files

  • Liked by
  • Bud Hyett
Bud Hyett posted this 30 December 2022

Eventually, any barrel will wear out. Surplus barrels are available, they will be probably now be set up with  a commercial reamer.

There is also the factor of the control of the groove and land depth in these barrels. (I have a Smith-Corona barrel with a .301 land and .310 groove depth. I'll be busy this Spring lapping a mold to fit.) 

We get rifles that were rebarreled at arsenals in peace time when the pace is slower and the chambers could rival commercial production. 

I do not think we should allow the newly made Criterion barrels from the CMP as substitutes, but any surplus military barrel should be allowed.  

I also think we might be beating a dead horse as the skill of the shooter for judging wind and mirage will outweigh any advantage of the rebarreled chamber.

Farm boy from Illinois, living in the magical Pacific Northwest

Attached Files

Premod70 posted this 31 December 2022

Thanks Gents for the clarity. I asked as the thought crossed my mine and my searches on the forum gave me no direction. Now I know and appreciate all the answers.

Dale Flinchum

Attached Files

  • Liked by
  • Ross Smith
Categories
Search
Popular Tags
This Weeks High Earners
Hot Topics
Close