How do you put the gas check on with the powder coating on the bullets. Lyman gas check. Thanks
Gas checks before or after powder coating
- 599 Views
- Last Post 07 December 2022
I prefer to install my GC prior to coating. All my gas checks are of the crimp-on variety, though. Slip-on checks might fall of during the shake?
The PC adds about 0,002in diameter, and if your shanks are on the large side in the first place, installing checks before coating is definately a good idea.
PS experimenting with checkless PC bullets might be wortwhile. I’ve had some pretty good results.
Attached Files
I agree with Spindrift. Leave the gas check off and see how it works. I have good luck with Lyman 357156 at .38 Spl. velocities all the way up to max. .357 velocities.
Attached Files
I use Hornady gas checks and Gator gas checks from Sages Outdoor. I started out seating the checks after PCing and had a lot of trouble so I switched to seating the checks before PCing with my Lee sizing dies and I can get MOA accuracy with all of my PCed cast bullets.
I finally have a place to hunt so I'm going to work my hunting loads with my cast for next year season.
Attached Files
For the moulds that i do gas check I do it after power coating but i do use a NOE gas check expander then size the bullet and crimps the gas check in place with out deforming the bullet
Attached Files
I have the NOE gas check expanders and I will do just about anything I can to keep from having to use them. They are a PITA to use to me.
I size and crimp GCs in Lee push through sizer before powder coating. I will size again after curing PC if necessary.
I use Sage Outdoors crimp on checks.
Rocky
Lifetime NRA since 1956, NRA Benefactor, USN Member, CBA Member
Attached Files
I watched a YouTube showing how to use a Lee factory crimp die to crimp on gas checks. Really cool.
Attached Files
Not all PC is alike, some will go on thicker than others and the same can be said for gas check shanks as some shanks in the same caliber from different mold makers will be different in dia. which can be problematic when trying to apply gas checks over coated bullets.
The NOE case check expands is a handy tool for when that problem arises, but for those bullets once I discover that issue I prefer to just apply the gas check first and coat over it.
'Artisan' in Lead, Brass & Powder.
Attached Files
Categories
- All Categories
- General Polls
- Contact Us w/ Forum Issues
- Welcome to The Cast Bullet Association Forum
- General
- Bullet Casting
-
Guns and Shooting
- AR Platform
- TC Contenders & Other Single Shot Handguns
- Shotguns
- Informal Matches & Other Shooting Events
- Gunsmithing Tips
- Gun Cleaning & Maintenance
- Optics
- Benchrest Cast Bullet Shooting
- Military Bench Rest Cast Bullet Shooting
- Silhouette Shooting
- Postal Match Cast Bullet Shooting
- Factory Guns
- Black Powder Cartridge
- Hand Guns
- Lever Guns
- Single Shot Rifles
- Bolt Action Rifles
- Military Surplus Rifles
- Plinkers Hollow
- Muzzleloaders
- Hunting
- Reloading
- Buy, Sell or Trade
- Other Information & Reference
Search
This Weeks High Earners
-
Aaron 29
-
RicinYakima 16
-
linoww 16
-
Tom Acheson 13
-
JeffinNZ 8
-
timinpa 7
-
beltfed 6
-
Boschloper 3
-
Bryan Austin 3
-
muley 3